One Step Buffing Cream for Gel Coat
Clean surface with
BOAT CLEAN PLUS™ and water, rinse and dry.
Light to Medium Oxidized Gel Coat:
1. Use a rotary buffer and wool pad at low to medium speed.
2. Apply EZ BUFF™ to a 2‘ x 2’ section with a brush or rag and prime the pad with EZ BUFF EXTENDER™ or EZ BUFF™.
3. Polish the area, with medium pressure, in a side to side and up and down overlapping pattern. As the buffing cream is consumed, reduce the pressure and keep
polishing until you achieve the desired gloss. If EZ BUFF™ begins to dry, spray with EZ BUFF EXTENDER™. Clean the pad often, against a sharp steel bar while
running the buffer.
4. Finish inaccessible areas by hand using EZ BUFF™ and a cloth. Repeat if necessary. Wipe clean with a microfiber cloth and protect with two
coats of PREMIUM BOAT SHINE™.
Heavily Oxidized or Stained Gel Coat:
Scrub the surface with BOAT SCRUB™ and a MARINE POWER MITT™
or rotary buffer and wool pad, then buff to a high shine with EZ BUFF™. Always keep damp. If BOAT SCRUB™ begins to dry, mist with water.
WARNING:May cause eye irritation. PRECAUTIONS: Avoid Contact with eyes.
Rinse mouth. Do NOT induce vomiting. Call a POISON CENTER or doctor if you feel unwell.
IF ON SKIN (or hair):
Wash off with soap & water.
IF IN EYES:
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.